Comments for Woodworking Maniak

Comment on 20in Hanging Chinese Checker Board by John

John — Sun, 28 May 2023 04:04:04 +0000

Bought this a year ago. Amazing board that has lasted. Awesome craftsmanship.

Comment on Long Cheese Slicer Assembly Kit by Kelly Vander Woude

Kelly Vander Woude — Sun, 30 Oct 2022 12:20:09 +0000

Works fantastic!

Comment on Long Cheese Slicer Assembly Kit by Jake

Jake — Sun, 13 Mar 2022 14:17:54 +0000

Awesome product got delivered fast, and was cheaper than any other place!

Comment on 20in Hanging Barricade / Malefiz by Phyl

Phyl — Mon, 13 Dec 2021 02:43:22 +0000

Very well made marbles stay in the game board the walnut is very nice

Comment on How to make a Cheese Slicer by WoodworkingManiak

WoodworkingManiak — Fri, 20 Aug 2021 16:45:52 +0000

In reply to Bob Bement. Here is a downloadable PDF with direction: Cheese Slicer Assembly Instructions

Comment on How to make a Cheese Slicer by Bob Bement

Bob Bement — Wed, 11 Aug 2021 00:02:27 +0000

It’s obvious that the hole for the cutter goes on the end grain and 4 inches deep and centered on the board end, I didn’t hear where to place the hole from the edge. 1/4 or 1/2 inch?

Comment on Chevron Cutting Board by WoodworkingManiak

WoodworkingManiak — Fri, 23 Jul 2021 19:50:27 +0000

In reply to Jeffery Levings. My wife has been using it for years and there have been no glue failures. Being that there isn't any stress on those joints, there isn't any reason for it to fail.

Comment on Chevron Cutting Board by Jeffery Levings

Jeffery Levings — Sun, 11 Jul 2021 03:16:37 +0000

Are you worried about it failing by glueing end grain to end grain. It isn’t a good joint for cutting boards

Comment on Retail Store Now Open! by WoodworkingManiak

WoodworkingManiak — Thu, 27 May 2021 13:41:17 +0000

In reply to Mike Emslie.

You can purchase them here: https://www.woodworkingmaniak.com/product/long-cheese-slicer-assembly-kit/

Comment on Chevron Cutting Board by WoodworkingManiak

WoodworkingManiak — Thu, 27 May 2021 13:40:50 +0000

In reply to Bea. I honestly don't remember. Due to cutting the angle, there is a bit of extra that is needed. I'll try to calculate and give you an estimate.